● Sim7600 gps not working The short of it is that I recently got a SIM7600G breakout board, it works with connecting with my SIM to the Internet and all, but I also receive the following in response to my setup: I am using the SIM7600E-4G-HAT module from Waveshare and I am unable to recieve GPS-Data by using the AT-Commands from the manual. 410 -> at+cgps? Has anyone ever gotten UE-assisted (A-GPS) mode to work on the SIM7600, let alone any Simcom module? If so, how did you get it to work? Is it a SUPL server issue? Q: Assisted GPS (AGPS) on SIM7600 module does not work. I recently got a SIM7600G breakout board and wanted to use it with the CGPS functionality for A-GPS. I had an extender cable on the GPS connector and it was not making a proper connection. org/forums/view 4#p1450784 In my project I want device location for that I am using SIM7600A-H 4g HAT module on top of Raspberry Pi 400 kit. I am able to send SMS that functionality is working fine, But the location service is not working, I am not able to power on any functionality (GPRS or CGNSPWR) with AT command. com:7276” AT+CGPSSSL=0 # set security mode AT+CGPS=1,3 # start gps in assisted mode This is response #CGPS: 0 How shall I do to get AGPS in sim7600g?. I’m currently facing an issue I can’t get GPS in assisted mode. I am interfacing the module with the Arduino IDE (Serial-Monitor) and tried the following: 14:40:57. Any time I run CGPS=1,3, I get a return of 0, meaning it's switched off. AT+CGSOCKCONT=1,”IP”,”CMNET” AT+CGPSURL=”supl. google. I'm currently using a Raspberry Pi together with SIM7600 from waveshare, a GPS/GSM module for 4G and GPS. The firmware itself was working properly so I did not need to update it. Unfortunately, the solution in this thread did not work for me. I would suggest that you follow the same steps that @lewisxhe suggested to make sure that the hardware is functioning properly. com:7276” AT+CGPSSSL=0 # set security mode AT+CGPS=1,3 # start gps in assisted mode This is response #CGPS: 0 How shall I do to get AGPS in sim7600g? The issue for me was a connection issue. The issue for me was a connection issue. The GPS-Antenna is connected to GNSS at the board. I have not found evidence of the Assisted Mode for A-GPS (AT+CGPS=1,3) working for anyone with any Simcom module (let alone my SIM7600A-H), but curious if anyone here has. raspberrypi. As of now, I have managed to setup the Raspberry Pi such that it can operate in standalone GPS and also 4G connection by following the guide from here: https://www. This is my AT command. If it is then Has anyone ever gotten UE-assisted (A-GPS) mode to work on the SIM7600, let alone any Simcom module? If so, how did you get it to work? Is it a SUPL server issue? Firmware? Any help would be greatly appreciated! Just a quick comment. fbkedpbvycktymnfidvsievopkhaxxtvsgnhgoijlpxtaeswfl